********FOR VOODOO1*********

Here are commands to copy and paist in your autoexec.bat.
these commands will double your FPS in outlaws.
i have helped over 30 players install these so
get ahold of old "WILDBILL"at the internet gaming
zone if you need help.

"WHERE IS YOUR AUTOEXEC.BAT?"
Here are 2 ways to find.
Go to mycomputer,c drive,autoexec
OR
Go to start,run,type in sysedit,click OK
Now just copy and paist the following commands
and go kick some arse!


SET FX_GLIDE_SWAPINTERVAL=0
SET FX_GLIDE_NO_SPLASH=1 
SET SST_SWAP_EN_WAIT_ON_VSYNC=0 
SET SST_GRXCLK=57
SET SST_GAMMA=1.7
SET SST_SCREENREFRESH=120 
SET SST_FASTPCIRD=1 
SET SST_FASTMEM=1
SET SST_VIDEO_24BPP=1 

"BEFORE INSTALLING PLEASE READ BELOW"



SET FX_GLIDE_SWAPINTERVAL=0 
When setting this to 0, you are not waiting for even intervals of your 
refresh rate. 
0 = off (might improve performance), to swap backbuffer/frontbuffer asap. 
1 = swap on vsync. 
2 = swap every two vsyncs. 

SET FX_GLIDE_NO_SPLASH=1 
Disable 3dfx spinning logo when 3dfx-card take over from the 2D videocard. 

SET SST_SWAP_EN_WAIT_ON_VSYNC=0 
Turns off syncing to the monitors vertical refresh rate so the screen gets 
refreshed before its fully written on the monitor. 

(optional)
SET SST_TRIPLE_BUFFER=1 
If program does no Z or no Alpha buffering then use aux buffer as hidden 
speed buffer! 

SET SST_GRXCLK=50 
This sets the frequenz of the 3DFX chip. Standard is 50, but you can go 
higher. This will however make the chip work faster/ more and make it warmer 
- and this could decrease the lifetime for the chip - be carefull! Some say 
55 is still safe - others say 57, but you should under no circumstance go 
higher (do at own risk!!!!). 

SET SST_GAMMA=1.7 
This sets the brightness for all colors at once and even. If the game is to 
dark, use this command (1.3 being dark - 1.7 default - 2.0 very light). 

SET SST_RGAMMA=1.70 
SET SST_GGAMMA=1.70 
SET SST_BGAMMA=1.70 
These commands sets the brightness for each color respectively (red, green, 
blue), so if all are set at once to the same value its easier to use 
SST_GAMMA. 

SET SST_SCREENREFRESH=75 
Sets the refreshrate for the chip. The lower setting, the less attention the 
chip has to do updating the screen. Set low keeps more workpower for gaming 
and set high improves picture quality - maybe only slightly (just compaire 
to 50MHz & 100MHz versions of televisions). But always check your monitor
manual for avalable refreshrate intervals. If you set SST_SCREENREFRESH to 
other than 60, then SST_GAMMA won't work unless you also 

SET SST_VIDEO_24BPP=1. Valid settings are 60, 75, 85 & 120. 

SET SST_FASTPCIRD=1 
Fast PCI Read option enabled, Subtracts WaitStates on PCI Reads
(Voodoo -> PCI) 

SET SST_FASTMEM=1 
Fast DRAM Configuration, Enables EDO Timing and compatibility. Makes the 
3dfx know you have EDO ram for faster performance.